Configuring the XM weather receiver
HP 4700, 5500 or older HP PDAs using Bluetooth
To configure the XM system, do the following:
1. Plug the XM unit into strong 12v-32v DC power (good power is critical!)
2. Start By making a Bluetooth Shortcut Tap on the Tower icon on the start screen
3. Tap the Manager by Bluetooth icon
4. Click New in the lower left part of the screen
5. Explore a Bluetooth device will already be selected
6. Click Next (It will beginning searching for Bluetooths in the area.)
7. XM BLUE DUN* will appear select it and Click Next.
8. Service Selection will display Bluetooth name (ex. XM RN; XM DATA) highlight name
9. Click NEXT
10. Click Finish!
This will take you back to the short cut page and you should see the shortcut you just created.
1. DOUBLE TAP icon.
2. Dial-up connection screen double tap on New connection
3. Type XM in the connection Name spot (tap the picture of a keyboard to bring it up; located on
the bottom toolbar right in the middle; leave other box’s blank)
4. HIT OK in the TOP corner
5. Connecting (you should see the blinking blue light go steady)
6. Leave User Name, password, domain BLANK
7. Hit Cancel (Its going to come up with a pop up that the connection has failed. That’s FINE!)
8. Tap OK
9. Exit Bluetooth manager
Run Anywhere Map (Start > Programs > Anywhere Map)
Once the map appears, go to File > Settings > WX Settings
Select the box that says XM WX
This will take you to XM Serial Configuration> Select Bluetooth Port 1
Enable XM should be check marked
Click OK