Search Tech Support Articles
 

Browse by Category
Glossary

SEPTA Update Instructions- Step by Step

Installing ULink for the first time

1. On your PC, download and install ULink from www.anywheremap.com/quadra. Check this site periodically for updated versions of the ULink program.

2. Power on SEPTA and Unlock screen.

3. Return screen to Main System Screen (shows 3 large icons for Pocket Plates, Anywhere Map and Via Anywhere).

4. Plug SEPTA into PC.

5. Open My Computer on PC and verify the SEPTA drive is displayed. If not displayed, wait an additional 30 seconds, if still not displayed unplug SEPTA and press the Reset button on the bottom of the SEPTA then plug into PC. 

6. Once SEPTA drive is displayed, close My Computer.


Using ULink to update your SEPTA

1. Double click the icon for ULink on your PC.

2. Choose Check for Updates.

3. Choose Download and Preinstall.

4. Choose Download and Preinstall again.

5. Continue until you have the following message: "Your SEPTA is not yet up-to-date. Please disconnect the SEPTA now and complete the installation using the SEPTA Updater on the device." At this point you will need to go to the taskbar and select the "remove device safely option". Failure to do this can cause a card failure.

6. Press OK on that message.

7. Unplug the USB cable from the SEPTA .

8. You may wish to plug the SEPTA into the wall charger at this point if your battery is low or you have several updates to install.

9. Press the Gears icon on the Main System Screen of the SEPTA .

10. Press Updates in lower left corner of Current Update Status screen.

11. The SEPTA will check for a WiFi connection and return the following question: "You do not appear to be connected to WiFi. Would you like to connect now?"

12. Choose No.

13. Once Available Updates have been found, choose Install.

14. Choose Install Now.

15. Quadra will begin to install all the downloaded files.

16. When Install Complete is displayed, choose OK.

17. You may now close out of the Update screen by press in Back and Close.


Your SEPTA is now up-to-date.

Email    Print

Related Articles

article Quadra Update Instructions- Step by Step
Installing ULink for the first time 1. On your PC, download and install ULink from www.anywheremap.com/quadra. Check this site periodically for updated versions of the ULink program. 2. Power on...

  4-06-2011    Views: 14976   
article Quadra / Septa XM won't update
The XM seems to be connected to the Septa / Quadra but it never shows new weather. It will even report that it is receiving new files if you tap the XM signal strength area. The issue...

(No rating)  8-08-2014    Views: 2857   
article Step by Step Backup & Restore for the iPAQ 4700 Series PDA
Depending on the battery age and the power management features of the hand held unit, every PDA has the potential to loose all of its settings and data. This loss occurs when the PDA is without...

  3-07-2006    Views: 4891